›
Continue to lift the vehicle until the wheel is just
o the floor.
Changing a wheel
›
Unscrew the screws and place them on a clean
surface.
›
Remove the wheel carefully.
›
Attach the wheel.
›
Slightly screw in the screws.
›
Lower the vehicle.
NOTICE
▶
Applies to factory installed or from ŠKODA Origi-
nal wheel covers supplied: Install the anti-theft
wheel bolt according to the position marked on the
back of the wheel cover.
Tighten screws
›
Tighten the opposite wheel bolts including the an-
ti-theft wheel bolt one after the other.
›
Reinstall the cover caps of the wheel bolts or the
full wheel covers.
Keep the label with the code number of the anti-
theft wheel bolts. Based on this, a replacement at-
tachment piece can be purchased from the ŠKODA
Original parts.
Breakdown kit
Content overview
The kit is located in a box under the floor covering in
the luggage compartment.
A
Stickers with the speed indication
B
Valve insert driver
C
Filling hose with sealing plug
D
Air compressor (the layout of the controls may
be dierent depending on the type of air com-
pressor)
E
Tyre inflation hose
F
Button for pressure reduction
G
Pressure display
H
12 volt cable connector
I
ON and OFF switch
J
Tyre inflation bottle
K
Replacement valve core
The declaration of conformity is included with the air
compressor or the log folder.
Conditions of use
Performing a repair with the breakdown kit not at all
intended to replace a permanent repair on the tyre.
The purpose of the repair is to get you to the nearest
specialist garage.
Change the tyre repaired by the breakdown kit as
soon as possible.
Before using the kit
›
Park the vehicle safely and secure it against rolling
away.
›
Turn o the engine.
›
Let all passengers get out. During the wheel repair
they should not stand on the road, e.g. behind the
crash barriers.
›
Close all doors as well as the luggage compartment
and engine compartment flaps.
›
If a trailer is coupled, uncouple it.
After using the kit
If a tyre pressure of 2.0 bar cannot be achieved, the
tyre is too damaged and cannot be sealed with the
puncture set.
›
Stop driving. Get the help of a specialist company.
Once a tyre pressure of 2.0–2.5 bar is achieved, con-
tinue the journey at a maximum speed of 80 km/h
(50 mph).
›
Avoid full throttle accelerations, hard braking and
fast cornering.
Instructions for driving with repaired tires
›
The pressure of the repaired tyre must be checked
after driving for 10 minutes.
›
If the tyre pressure is 1.3 bar and less, do not con-
tinue! Get the help of a specialist company.
›
If the tyre pressure is higher than 1.3 bar, correct
the pressure to the correct value of at least 2 bar
and continue driving.
NOTICE
Danger of compressor damage!
▶
After the maximum running time of the air com-
pressor has expired, let it cool down for a few mi-
nutes.
131
Wheels › Breakdown kit
To Next Page
Loading...
Need help?
General
