›
Hold the raised cover
in place and press the
underside of the cover
on both sides.
›
Remove the cover.
Inserting
›
Insert the holder A
opposite the holder B
on both sides of the
luggage compartment.
›
Press on the cover
from above until it en-
gages.
›
Hook in the retaining
straps.
Store the cover behind the rear seats
›
Insert the cover behind
the rear seats.
WARNING
The luggage compartment cover stowed behind the
rear seats restricts the driver's rear view.
Roll-up luggage compartment cover
Operation
Pull out and roll up
›
Hook the locking lugs
A
at the supports
B
.
›
Roll it back takes place in reverse order. Hold the
cover and let it roll up slowly.
Remove and insert
Take out and insert the roll-up cover
›
Press the end of the
crossbar and take out
or insert the cover.
Variable loading floor in the boot
Setting the position
The maximum load of the variable loading floor is
75 kg.
Set the variable loading floor to the upper or lower
position
›
Lift the variable load
floor and pull it to-
wards you.
›
To set in the upper po-
sition, position the vari-
able loading floor in the
front area on area
A .
›
To set in the lower po-
sition, position the vari-
able loading floor in the
front area on space
B .
›
To form a connection
to seats that have been
folded forwards, lay the variable loading floor in the
front area on surface
C .
›
Press the variable load-
ing floor forward and
hang up.
207
Storage space and interior equipment › Roll-up luggage compartment cover
To Next Page
Loading...
Need help?
General
