Skope BC070-CB - Troubleshooting

17
SKOPE Centaur Series
Servicing
User Manual
Troubleshooting
Complaint Possible Cause Repair
1. Cabinet not
operating and
no controller
display:
• Loss of power supply. • Check that the cabinet
power switch is turned on
(see page 10).
• Check mains power supply.
2. Power
consumption
is higher than
expected:
• Unit operating too hot. • Clean condenser. Ensure
the cabinet is installed with
good ventilation around the
refrigeration unit.
• Cabinet doors are opened
excessively.
• Keep door/s open for
minimum time.
3. Product is too
warm and
spoiling:
• Restricted cabinet airflow. • Ensure product is not
blocking airflow slots and the
product is no closer than
75mm from the cabinet top.
• Temperature setpoint is too
warm.
• Adjust setpoint (see
page 13).
• Food preparation covers
raised for extended periods.
• The covers must stay closed
when not in use (see
page 9).
4. Warm cabinet
temperatures
and/or
compressor
operating for
long periods
(more than 1
hour):
• Blocked condenser. • Clean condenser coil (see
page 15).
• Poor refrigeration unit
ventilation.
• Ensure the cabinet is
installed with good
ventilation around the
refrigeration unit.