sky viper S1700 - Product Contents and Components; Included Accessories List; Batteries and Maintenance Guide; Remote Battery Installation

To Previous Page

3 x1.5 V AAA (LR03)

+ AAA/LR03/R03 1.5V –

– AAA/LR03/R03 1.5V +

LiPo BATTERY

FRONT

BACK

Bottom View of Drone

GREEN

BLADES

BLACK

BLADES

ALKALINE BATTERY CAUTIONS

• Do not use rechargeable batteries.

• Non-rechargeable batteries are not to be recharged.

• Rechargeable batteries are only to be charged under adult supervision.

• Different types of batteries or new and old batteries are not to be mixed.

• Only batteries of the same or equivalent type as recommended are to be used.

• Batteries are to be inserted using correct polarity.

• Remove exhausted batteries as soon as possible and discard properly.

• Remove all batteries from compartment if toy is not used for a long period.

• The supply terminals are not to be short-circuited.

• Never throw batteries in a fire or attempt to open the outer casing.

• Battery should be replaced by adult.

WARNING:Batteries are harmful if swallowed. Please keep away from children.

Battery Disposal: Dispose of batteries according to the local laws and regulations of your region. Some

batteries may be recycled, and may be accepted for disposal at your local recycling center. If you are not

able to identify the applicable rules in your area, please check the instructions of the battery manufacturer.

THIS PRODUCT CONTAINS A LITHIUM-POLYMER BATTERY3.7V 650mAh:

LiPo batteries have a severe risk of fire and injury if they are improperly handled or misused. They

may explode, overheat or ignite.Read all following precautions and instructions regarding the

care and use

of LiPo batteries. The enclosed LiPo battery is only to be used with the drone and charger

included with this product.

• Keep away from flammable materials.

• Do not expose to direct sunlight.

• Do not place in fires or leave in hot places.

• Do not drop or make subject to strong impact.

• Keep dry and away from water.

• Remove exhausted batteries as soon as possible and discard properly.

• Remove all batteries from the compartment if toy is not used for a long period.

• The supply terminals are not to be short circuited.

• Never throw batteries in a fire or attempt to open outer casing.

LiPo Battery Disposal: LiPo batteries must be recycled or disposed of properly. They should

not be disposed of with other household waste. Check your local laws and regulations for

correct recycling and/or battery disposal.

BATTERY REPLACEMENT

Double your flying time with a 2nd battery!

Details of how to purchase additional or

replacement battery packs available at

SKYVIPER.COM

Viper and Skyrocket and their respective logos are trademarks and/or

registered trademarks of Skyrocket Toys LLC. All other trademarks, logos and

copyrights are the property of their respective owners, and there is no

relationship express or implied with Skyrocket Toys LLC.

MADE IN CHINA.

Remove all packaging attachments before giving the toy to a child.

Not suitable for children under 3 years due to small parts that could be swallowed.

Conforms to product safety standards ASTM F963.

Keep instructions for future reference. Do not discard.

This device complies with PART 15 of the FCC Rules. Operation is subject to the following two conditions. (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

CAUTION: Changes or modifications to this unit not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna - Increase the separation between

the equipment and receiver - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected - Consult the

dealer or an experienced radio/TV technician for help.

CHARGING PRECAUTIONS:

• After use, allow drone (battery on bottom) to cool down to room

temperature before charging again.

• Charge drone in an isolated area, away from excessive heat

or moisture.

• If you suspect that the battery is damaged or swelling, turn off the

drone immediately.

• Do not modify, heat, or wet the battery in any way. Only recharge with

provided charger.

1 Disconnect battery wires. Push down the battery

box holder on the rear side of the drone. Pull

battery box out of underside of drone.

3 Insert LiPo battery into back of drone.

Reconnect the battery wires.

2 Plug charging cord into computer or USB

power block. Once charged, disconnect

battery from USB charging cable.

CHARGING THE DRONE

Plug into charging wire Push down Disconnect battery wires Pull battery box out

• RC Hover Racer Stunt Drone

• Screwdriver

• Screws

• USB Charging Cable

• 4 Replacement Blades

• 4 Beacons

• 4 Beacon Bases

• Alternative Pro Thumbsticks

• Rechargeable 3.7v 650mAH

LiPo Battery

• Remote Control

1 Unplug battery on drone.

2 Make note of the blade color and letter

(A or B) before removing the blade

from Drone. (Markings are located on

the underside of blades and Drone).

3 Remove the small screw using the mini

screwdriver provided.

4 Replace the damaged blade with a new

blade with matching color and letter.

Secure the blade with the retaining screw.

MAINTENANCE

• Over time, loose hair or carpet fibers may get wound in blades, reducing

performance. Unplug the Drone and remove fibers from motors. (Remove

blades if necessary)

CONTENTS REMOTE BATTERIES

REPAIRING DAMAGED BLADES

Loosen the screw in

the Remote Control

battery compartment

door with a Phillips

screwdriver and insert

batteries as shown.

Replace door and

tighten screw.

Battery tray includes

security screw to prevent

child access to LiPo battery.

Users over 14 years of age

may remove screw from tray

for easier access.

BATTERIES AND MAINTENANCE

S1700

• Lift joystick upward to remove.

• Insert thumbstick into stem to replace.

ALTERNATIVE

PRO THUMBSICKS

Plug in USB cable

Red light = charging

Green light = fully charged

The software included in this product contains copyrighted software that is licensed under the GPLv3. A copy of that license is included in our website at the URL below. You may obtain the complete Corresponding

Source code from us for a period of three years after our last shipment of this product and/or spare parts therefor, which will be no earlier than 05-01-2019, on our website at http://www.skyrockettoys.com/GPL/

sky viper S1700 - Product Contents and Components; Included Accessories List; Batteries and Maintenance Guide; Remote Battery Installation

Related product manuals