Need help?Do you have a question about the Sky Glass LT055-f2-zzz and is the answer not in the manual?
General| Screen Size | 55 inches |
|---|---|
| Resolution | 3840 x 2160 (4K UHD) |
| Operating System | Sky OS |
| Integrated Speakers | Yes |
| Voice Control | Yes |
| HDMI Ports | 4 |
| Ethernet | Yes |
| HDR Support | Yes |
| Wi-Fi | Yes |
Remove the stand by placing the TV face down and unscrewing the four highlighted screws.
Remove four spacers and then unscrew the 3 and 22 screws on the bottom of the unit to detach the rear cover.
Details the removal of wires and various circuit boards, including component identification.
Identifies the main circuit boards labelled A through G for reference during disassembly.
Instructions for removing the mylar film, LVDS wire, and unlocking corks to release the IR Board kit.
Guides on removing tape marked in red and unplugging 10 specific wires from the assembly.
Procedure to remove foam and screws (x8) from the bracket found underneath the main unit.
Steps to remove the Mic Board by unscrewing (x1 yellow, x4 red) and unplugging its wire.
Instructions to remove the Key Board by detaching tape and unscrewing (x2) before unplugging the wire.
Guidance on removing the Driver Board by detaching the five highlighted screws.
Steps to remove tape and separate the WIFI and BT module pins using a soldering iron.
Procedure to unplug FFC cables and remove ten highlighted screws to detach the Main Board.
Instructions to remove seven screws and desolder ten electrolyte capacitors from the Power Board.
Steps to remove mylar film (x2) and then unscrew (x2) and unplug wire (x2) to remove the T-con board.
To Next Page
