Sky Sky+HD - Overview

Connect satellite
cables
Connect telephone line
2. Connecting your box
Carefully move your TV and Sky± box away from the wall, ensuring no cables are pulled out or over stretched. Once you can reach all of the connections at the
rear, unplug and set aside your Sky± box, replacing it with your new Sky±HD box.
4
Connect telephone line
Note: Be careful to not insert your telephone line into the green Ethernet socket.
This is the existing telephone line that was used to connect your Sky± box. If this is currently not in place,
please ensure you connect a telephone line so that you can activate your viewing card and channels in step 4.
Connect satellite cables
These are the existing satellite cables that were used to connect your Sky± box to your satellite dish.
It does not matter which satellite cable is connected to Dish Input 1 or Dish Input 2. Ensure you do not
bend the copper wire in the middle of these connections and that you screw the satellite cable all the
way onto the back of the box until it is secured tightly.
Note: If you have one satellite connection, please refer to the “I only have one satellite connection
from the dish to my box” in the troubleshooting section at the back of this guide.
Remove SCART cable
You can remove the SCART cable completely from your TV, it will be replaced by your HDMI cable.
Remove SCART cable