Skycut Series D with SignCut Pro2
July 3, 2020
You can expect updates to this manual over the next few months
Do NOT read this entire manual… unless you want to.
• At the start of Chapters 1 - 4 are short sections with references to find what you need plus some important
reminders. PLEASE read these short sections at the very least and refer back to them, when needed.
• Chapters 1 and 2 are very important in terms of correctly setting up your Skycut to work with SignCut Pro2
and learning the ins and outs of cutting.
• Chapter 3 is for those owners wanting to perform print and cut applications.
• Chapter 4 covers using Skycut accessory tools and dual head applications.
• Chapter 5 covers several SignCut Pro2 functions of interest: creating contour cuts and engraving fills.
It’s not practical to print this entire manual because:
• It’s a waste of paper and ink if you only ever need certain sections.
• The live links to videos and web sites in the manual will not work.
• This manual will be updated from time to time.
• You cannot search on individual words.
Also:
• Videos of interest can be found at the following link: Skycut Support Videos
________________________________________________________________
© 2018-2020 Sandy McCauley All Rights Reserved
To Next Page
Need help?
General