Skycut Series C with SignCut Pro2
January 3, 2020
Do NOT read this entire manual… unless you want to.
• At the start of Chapters 1 - 4 are short sections with references to find what you need plus some important
reminders. PLEASE read these short sections at the very least and refer back to them, when needed.
• Chapters 1 and 2 are very important in terms of correctly setting up your Skycut to work with SignCut Pro
and learning the ins and outs of cutting.
• Chapter 3 covers contour cutting (aka print and cut) applications.
• Chapter 4 covers the Skycut accessory tools.
• Chapter 5 covers several SignCut Draw functions of interest: vectorizing, editing, and engraving fills
It’s not practical to print this entire manual because:
• It’s a waste of paper and ink if you only ever need certain sections.
• The live links to videos and web sites in the manual will not work.
• This manual will be updated from time to time.
• You cannot search on individual words.
Also:
• Note the green icons which link to videos related to the section in which they are located. These
videos will enhance your learning experience.
________________________________________________________________
© 2019-2020 Sandy McCauley All Rights Reserved
To Next Page
Need help?
General