Skycut C16 - Back; Accessories; Test Pen; Skycut Blades

9
Back
1.07 Accessories
1.07.1 Test Pen
• The test pen should be used until you are comfortable with the operation of your Skycut and know, with
certainty, where images will cut. The test pen should arrive pre-assembled. However, if you need to change
out the insert, note how the test pen is assembled:
1.07.2 Skycut Blades
• There are three kinds of blades that fit inside the Skycut blade holder:
 The 45
0
red capped blade is suited for cutting thinner materials such as paper, all cardstock types, heat
transfer vinyl, and wall/auto/decal vinyl.
 The 60
0
blue capped blade is a much longer blade and is well-suited for cutting thicker materials, such
as gum paste, craft plastic, craft foam, and rhinestone template material.
 Sold separately is the 30
0
yellow capped blade which is a wide blade and well suited for cutting fabric,
felt, and tint. It has been reported that it also works well with cardstock that has been exposed to
humidity.
Red Blue Yellow
Pinch wheel lever
Pinch wheels
Spring goes over the top of the
pen insert and stops at a small
ridge on the insert