Troubleshooting
If you are having trouble operating your Beacon accessory, please visit
https://skydio.com/support for the latest guides and troubleshooting articles.
Compliance Information
FCC
Any changes or modifications to this equipment not expressly approved by Skydio for
compliance will void the user's authorization to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
● Consult the dealer or experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
For body worn application, this device has been tested and meets FCC RF exposure guidelines
when used with the Skydio 2. Use of other accessories may not ensure compliance with FCC
RF exposure guidelines.
To Next Page
Loading...
Need help?
General