Part 10: Q & A
1：Can the remote control install other apps?
The permissions of the remote control are all open, and there is no special software or restricted software
installation and uninstallation.
2:How does the remote control enter the fast charge mode?
Only under using the original charger to enter the fast charge mode, and there is a text prompt on the lock
screen interface.
3:How to get the RTSP address when using MIPI or HDMI camera?
Open the H16 helper, open the video to view, click on the settings (virtual button), click on the video stream
address, click on custom to copy the link below that starts with RTSP. Then paste.
4:Data transmission/telemetry cannot be connected.
Check whether the ground station is connected with UDP way to connect to the TX and whether the listening
port of the RX’s port 0 is 14551. Check whether the baud rate is normal. Check if RX and TX is connected
reversely (connect RX to TX TX to RX correctly).
5:The video/image cannot be displayed after connecting to the webcam.
The video/image transmitted through the network port has a dedicated RTSP address. Not compatible with
MIPI/HDMI. This RTSP address needs to be consulted with the webcam manufacturer.
6:The remote control's network port cannot be connected to the Internet.
Please turn off WIFI when connecting 5G network card or network port.
7:The remote control cannot connect to WIFI.
The remote control can only connect to the 5G band WIFI, and the mobile phone can change the hotspot to the
5G band hotspot.
8:Unable to share data/telemetry or video transmission.
Please check if there is a hotspot connected to the remote control.
15
To Next Page
Loading...
Need help?
General
