îîîîî
îîîîîîîîîîş SJIII Series
Section 1 - About Your Aerial Platform
Safety Precautions
Know and understand the safety precautions before going on to next section.
îîîîî
îî
îîîî§îîîî îîî î îîîî îî îî îîî§î§îîŻîîîî îîîîîîŽî
îîîîîîîîîîîî îîîî§îî îîîîî§îî îîî îîîî îî˛îîîî
îîî§î§îîîîîîîîîî îîîîîîîîîîî îîîî îîťîîîîîî§îîîîîîî
îîîîîîîî îîîîîîîîîîîîîîî°îîîŽîĽ
îźî îîîî all national, state or territorial/provincial
and local rules which apply to your aerial platform
and jobsite.
îźî îîîîîthe (emergency) main power disconnect
switch off when leaving the aerial platform
unattended. Remove the key to prevent
unauthorized use of the aerial platform.
îźî îîîî all the protective clothing and personal
safety devices issued to you or called for by job
conditions.
îźî îîîîîî wear loose clothing,
dangling neckties, scarves,
rings, wristwatches or other
jewelry while operating this
lift.
îźî îîîî
îî entanglement with
ropes, cords or hoses.
îźî îîîî
îî falling. Stay within the
boundaries of the guardrails.
îźî îîî îîîî raise the aerial
platform in windy or gusty
conditions.
îźî îîî îîî increase the lateral
surface area of the platform.
Increasing the area exposed
to the wind will decrease aerial
platform stability.
îźî îîîîîî drive or elevate the
aerial platform if it is not on a
firm level surface. Do not drive
elevated near depressions
or holes of any type, loading
docks, debris, drop-offs and
surfaces that may affect the
stability of the aerial platform.
îźî î
îî îîîîîîîîîî îîî îîîîîî
îîîîî îîîîîî îîî îîîîîîîîîî
îîî îîîîîîîîîî î îîîĄîîîîîî î
elevated driving shall not be
allowed. Position the aerial
platform horizontally only with
the platform fully lowered. After
ensuring that all 4 wheels or
outriggers (if equipped) have
contact with level firm surface,
the aerial platform can be
elevated. After elevation, the
drive function must not be
activated.
îźî îîîî˘îîîîî îîîî˘îîîŁ must
only be done on a firm level
surface.
îźî îîîîîî ascend or descend
a grade when elevated. When
fully lowered, ascending or
descending, only grades up
to rated maximum listed in
Table 2-1 are permissible.