5. OPERATION
When the battery level on the sensor drops to a certain level, or the sensor
is out of the operating range, the receiver will show a “loss of signal”
indication. The red LED representing that zone will flash rapidly, i.e. if
zone 1 sensor is lost, the zone 1 red LED will flash rapidly.
When the loss of signal indication occurs, move the receiver closer to the
corresponding sensor and trigger that sensor. If the red LED stops flash-
ing rapidly, that means the receiver or sensor needs to be relocated. If the
“loss of signal” indication persists, replace the battery of that sensor.
6. LOSS OF SIGNAL INDICATION
7. OTHER HOUSEHOLD ALERT
®
SENSORS
The Household Alert
®
receiver can work with up to 4 different sensors:
garage door monitor sensors, door / window sensors, water sensors,
indoor/outdoor motion sensors, etc. Please visit www.skylinkhome.com
or contact us at support@skylinkhome.com for more information of how
to fully utilize your Door/Window Sensor.
8. WARRANTY
If you would like to order Skylink’s products or have difficulty getting
them to work, please :
1. visit our FAQ website at www.skylinkhome.com , or
2. email us at support@skylinkhome.com, or
9. CUSTOMER SERVICE
If, within one year from date of purchase, this product should become
defective (except battery), due to faulty workmanship or materials, it will
be repaired or replaced, without charge. Proof of purchase and a Return
Authorization are required.
CAPITAL PROSPECT LTD.
Rm.1303, 13/F, Block B, Veristrong Ind. Centre,
36 AuPuiWan Street, Fo Tan, Hong Kong
Tel: (852) 2602-1318 Fax: (852) 2602-4684
Email:support@skylinkhome.com
http://www.skylinkhome.com
P/N. 101A254-001 Rev.1
©2005 SKYLINK GROUP
When the magnetic contact is broken, such as when the door or window
is open, the sensor will send a signal to the receiver, and the receiver will
beep and the corresponding zone red LED will flash.
If the sensor is set to zone 1, zone 1 red LED on the receiver will flash,
and the receiver will emit a continuous “single beep”, i.e. “beep” pause, “beep”,
pause….. etc.
If the sensor is set to zone 4, zone 4 red LED will flash, and the receiver will
emit a con-tinuous “4 beeps”, i.e. “beep beep beep beep” pause “beep beep
beep beep” pause ……etc.
By the number of beeps emitted by the receiver, user can identify which zone
is triggered.
To Previous Page
Loading...
