Section 2 - Programming the Sensor with M-Series Main Console
1. Press the learn button on the back
of the M-Series Main Console for
3 seconds until the Zone 1 light
is ashing.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including
interferences that may cause undesired operation.
Congratulations on your purchase of the Skylink Door/Window Sensor,
Model: WD-MT. The sensor will monitor the door/window status and works
with the SkylinkNet Internet Hub and the Skylink M-Series Alert/Alarm System.
INSTALLATION INSTRUCTIONS
Door/Window Sensor
Model: WD-MT
Safety Information
WARNING:
Changes or modications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
CE - DECLARATION OF CONFORMITY:
This equipment complies with the requirements relating to electromagnetic
compatibility, EN 301489-1, EN301489-3, EN300220-1, EN300220-2 and
EN60950-1. This equipment conforms to the essential requirement of the
1999/5/EC R&TTE Directive.
B
NOTE: You can program in total up to 4 sensors in one zone. If you try to
program the fth sensor, the rst sensor will be removed.
2. Zone 1 is selected. Press the learn
button to select the zone you want
to program the sensor.
4. Once the sensor is programmed,
the Main Console will beep once and
the corresponding zone led will be off.
A
Section 1 - Insert a battery in the Door/Window Sensor
NOTE: The battery for the Sensor is not included. Please refer to
instruction below to insert an AAA Alkaline Battery.
Learn Button
Section 3 - Programming the Sensor with SkylinkNet Internet Hub
1. Go to “More” and tap
on “System Settings”.
2. Tap on “Setup
Wizard”
3. Tap on “Add Device”
NOTE: Programming the sensor with the SkylinkNet Internet Hub
must be done from the SkylinkNet App.
4. Tap on “Door Sensor”
or “Window Sensor”
5. Name your Sensor,
location and tap
“Continue”
6. Tap on “Learn Now”
and follow the video to
activate the sensor.
Package Contents
C
1. Press both sides and open the cover of the Door/Window Sensor.
2. Insert an AAA Battery in the sensor and close the cover.
Zone LED
3. Activate the Sensor by
seperating the magnetic
contact of the sensor.
4. Tap on “Sensors”
Parts
Description Quantity
A Door/Window Sensor 1
1MagnetB
C Mounting Accessories
1
To Next Page
Need help?
General
