EasyManua.ls Logo

SKYLOTEC ACX - Page 37

SKYLOTEC ACX
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
37
5.9) Storage
Always clean and dry the Ascender and the transportation box before storage. See section G for cleaning instructions. Always store the Ascender,
Batteries and the Remote Control dry at a temperature between 5°C (41°F) and 25°C (77°F). For more detailed Battery storage information, see section
E.09.
WARNING: Always store the Battery fully charged. The Battery can stay connected to ACX during transport or short term storage (1 week). For longer
storage, store the Battery disconnected and perform a maintenance charge every 3 months.
5.10) Checklist before use
Always check the Ascender before every use. Check the Ascender thoroughly and in accordance with your training and this manual. If you are in any
doubt about the condition of the Ascender, do not use it and contact your SKYLOTEC supplier or SKYLOTEC directly.
Inspection of ACX Battery Pack:
no damage to Battery Housing
connector pins clean and
not damaged
battery charged
battery Strap present
Inspection of ACX Ascender
Check the Ascender housing for cracks or severe damage
Check the Battery Connector
pins on the Ascender:
– Clean and no damage
Rubber sealing rings should be present (see below)
Slide the Battery on to the Ascender and check that the Battery is locked in its position
Rubber
sealing ring