36
Remote Control Battery
The Remote Control unit is equipped with an internal battery which is charged via the supplied USB cable. Complete charging
will take up to 150 minutes via a computer, or 75 minutes with the supplied adaptor. The USB Connection Point can be found
on the bottom of the Remote Control under the protection cap that can be unscrewed.
The power LED on the Remote Control will turn red at 20% charge. The power LED will ash during charging and will be steady lit
green) once charging is completed.
WARNING: Make sure that the Remote Control has visual contact with the Ascender to ensure safe operation and maximum range. When using the
Remote Control, should the unloaded rope be held by an operator to ensure that the rope can run unhindered into the Ascender while lowering.
Uncontrolled rope running into the Ascender can cause a rope jam and eventually rope damage.
NOTE: Always use the Remote Control in combination with a stop knot at the end of the rope!
5.8) Transportation
Carry the Ascender by the lifting handle for short walking distances. When carrying the Ascender any further stow it in the transportation box as this
will protect the Ascender from any damage. Make sure the Ascender is secured when travelling in any vehicle.
NOTE: The Ascender Batteries hold over 100 Wh of power and are therefore fully regulated as Dangerous Goods (Class 9 UN3480 Lithium Ion
Batteries) and must be handled and shipped accordingly. Contact your SKYLOTEC distributor or SKYLOTEC directly for further details.
To Next Page
Loading...