35
4. Operate the Ascender
Hold
down
By pushing either the ‘UP’ or
‘DOWN’ button the Remote
Control will take over the control
of the Ascender and
the Ascender will
stop immediately.
5. De-activation
Switch off the remote control. The
Remote control will switch itself
off after 30 min of its last use.
WARNING: The Remote Control will only work with the Ascender it has been delivered with. The serial number of the assigned Ascender is indicated
on the Remote Control. In case of using multiple Ascenders, mark your Remote Controls to avoid any confusion. When using the remote control, make
sure a distance of at least 20 cm (8”) is kept between the remote control and your torso and/or head. Contains FCC ID: SQGBT700.
NOTE: Remote Control does not work if Emergency Stop is pressed or if the Ascender is switched off. Once the Ascender is switched back on again
the Ascender can be used manually. The remote connection needs to be re-established by turning the Remote Control off and on again.
To Next Page
Loading...