JP-009、JP-010T
JP-009、JP-010T
JP-010S
Degas light will be on if press”DEGAS”,that is,ultrasonic will work 9 seconds, then pause 6 seconds until
the default time is over.
This operation is applicable to models with degasification. 010S does not have degasification
Heater light will be on when touch “HEAT”; heater will be automatically off when
temperature up to 65℃.Touch the button again if need pause.
Set the working time, 7 setting times can be chosen: 60s, 180s, 300s, 600s, 30-
mins, 60-mins. Touch “ON/OFF” button after set the time well, ultrasonic light
will be on and machine starts to work until the default time is over. Touch
“ON/OFF” again if need to pause when working.
JP-010S
DEGAS FUNCTION
Plug the cleaner into a grounded outlet. Turn on the power switch at the
tank back, then machine is power on.("O" is closed, and " " is open)
Add appropriate amount of cleaning solution to the cleaning tank accord-
ing to the cleaning. Ensure that the liquid level is not lower than the inner
tank height by 2/3 when the heating is turned on. Use flammable liquids
such as alcohol, gasoline, etc. It is forbidden to heat. Long-term vibration
will cause liquid increase in temperature, beware of fire!
1. Add cleaning liquid
2. Open power
For the first Boot, time display show setting time at random, press/touch time key
+ one time, ‘’the setting time’’ on the display increase by 1 minute corresponding-
ly, Touch time - Key to decrease time setting by 1 minute. Touch ON/OFF switch
after set the time well, ultrasonic indicator turns red and machine starts working
based on specified the parameters, meanwhile timer begin to count down and
stop working until time shows”00:00”, automatically.
For the first boot, the setting temperature on the display is random, and actual
temperature is room temperature. Touch TEMP+ once to increase temperature
by 1℃; Touch TEMP- once to decrease temperature by 1℃. Temperature
display shows setting temperature and actual temperature when heater is
working, the heater indicator goes off when actual temperature reaches setting
temperature.
OPERATION STEPS
Before Operating Your Cleaner
Start ultrasonic cleaning
Heat
www.skymen.cc
To Next Page
Loading...