RADIO CONTROLLED DIGITAL CLOCK
MODELS 88905 / 88906
QUICK SETUP GUIDE
IMPORTANT! INSTALL BATTERIES IN THE OUTDOOR TRANSMITTER
BEFORE INSTALLING BATTERIES IN THE RADIO-CONTROLLED CLOCK.
ALKALINE BATTERIES ARE RECOMMENDED FOR USE IN BOTH UNITS.
PLEAE AVOID USING RECHARGEABLE BATTERIES IN THESE DEVICES. DO
NOT MIX OLD AND NEW BATTERIES. DO NOT MIX ALKALINE, STANDARD
(CARBON-ZINC), OR RECHARGEABLE (NICKEL CADMIUM) BATTERIES.
SETUP INSTRUCTIONS
1. Place batteries in the outdoor transmitter.
2. Insert batteries into the clock.
After approximately 15 minutes both the Indoor and Outdoor areas on your clock should
have a temperature showing. If not, remove both sets of batteries, wait 15 minutes and
repeat step one.
TO INSTALL OR REPLACE BATTERIES IN TEMPERATURE TRANSMITTER
The transmitter uses 2 x AAA 1.5v batteries. To install and replace the batteries, please
follow the steps below:
1. Remove the battery cover by pushing down towards bottom of transmitter and sliding
cover out.
2. Insert the batteries, observing the correct polarity (see marking inside battery
compartment).
3. Replace the battery cover on the unit.
TO INSTALL OR REPLACE BATTERIES IN THE CLOCK
Insert 2 fresh AA, LR6 1.5 volt ALKALINE batteries in the battery compartment
according to the polarity marked on the case.
Once the batteries are installed, the clock will begin searching for a signal.
To Next Page
Need help?
General