DSAT-300 USER GUIDE 2
Document Rev. 1.015 DOC0594 Page 2 of 28
Restricted Proprietary and Confidential Information
PROPRIETARY NOTICE:
The information contained in this document is proprietary and confidential to SKYTRAC Systems Ltd.
Warning
Changes or modifications not expressly approved by SKYTRAC Systems Ltd. could void the user’s authority to
operate the equipment.
Warranty Information
SKYTRAC Systems Ltd (STS) warrants this product to be free of defects in materials and workmanship, and that
the product meets or exceeds approved factory acceptance test requirements. STS reserves the right to replace
any warranted product at its sole discretion during the warranty period.
The DSAT-300 Airborne Data/Position Communicator (except for the Li-ion battery P/N: STS0065) is under
warranty for one year from date of shipment from SKYTRAC Systems. For failed units caused by defective parts or
workmanship, contact SKYTRAC Systems for an RMA #. Once an RMA # has been obtained, the unit should be
returned to: SKYTRAC Systems will provide the return address to ship the equipment to at the time of issuing the
RMA #.
ESD Caution
The DSAT-300 contains static sensitive circuitry that could be damaged from large electro static discharges directly
into the connector pins. Use care when handling the DSAT-300 not to touch the connector pins unless properly
grounded.
Disclaimer
Devices other than the DSAT-300 mentioned in this manual do not necessarily have regulatory approval for
installation in your airframe and may require additional approvals. Please refer to the applicable STC for approval
information.
To Next Page
Loading...
Need help?
General
