8
FOR PUSH FIT & CLAMPED POLES:
1. Insert end tool into neck of tool holder. (not shown).
2. Aach tool holder to head of the top / highest pole.
3. Build poles up to the required height – starng at the top pole (with the end tools)
and working down. Add each new pole below the previous.
4. Rest the poles against a side of a building whilst building.
5. Ensure the Vac release pole is the base pole (clamped poles only).
6. Once the pole is assembled to the required height, aach the so cu end of the
wire reinforced hose, onto to the base of the pole.
7. Switch on.
STEP 2
STEP 4
STEP 6
STEP 5
STEP 3
TOP TIP:
Assemble your poles up against the side of the building you are
working on so you are ready to start!
To Next Page
Loading...
