4. Locate one of the D-rings (11) attached to the upper
edge of the Netting. Lift the D-ring (11) and hold it close
to an L-tube (5) as shown in Inset Drawing A. Insert one
of the Straps through the D-ring (11) on the Netting (10).
(See Inset Drawing A). Next, thread the end of the Strap
under the Foam Sleeve (9) on the L-tube (5) and up
through the two D-rings on the opposite end of the Strap
(11). (See Inset Drawing B.) Then thread the end of the
Strap (11) back down through the lower D-ring (11) on
the Strap. (See Inset Drawing C.) Pull the loose end of
the Strap to remove any slack but do not fully tighten the
Strap (11) at this time.
Warning: Take care not to fall, use a ladder if needed.
Attach the Netting (10) to the other three L-tubes (5) with
the other Straps (11) in the same manner.
5. Tighten the Straps (11) attaching the Netting
(10) to the L-tubes (5). (See Step 4.)
Tie the free end of each Strap (11) around the rest of the
Strap (11) to prevent the Strap from becoming loose.
6. Tighten the Straps (11) (not shown) on the underside
of the frame pad. See Trampoline manual page 15.
7. Now insert the end cap (13) into the bottom of the T-
Bracket.
Your trampoline enclosure is now fully assembled (put
together). Make sure that all parts are securely attached.
Familiarize yourself and all users of the trampoline and
enclosure with the safety precautions, use and instruction-
al materials, and care and maintenance instructions in this
manual before using the trampoline and enclosure.
10
Inset Drawing A B C
To Next Page
Loading...
