Skywalker sjg200 - Page 12

2
9
15
15
14
14
16
16
17
17
13
18
18
19
19
6
6. First find the Side Uproght 1(2) and the
Middle Upright 1 (9) with marked 2,9.
Attach two Plastic Protectors (14) to the
Short Cross Bar (6) with two M6 X40mm
Button Bolts (16), two M6 Washers (17) and
two M6 Locknuts (15).
Then fix the Side Uproght 1(2) and the Middle
Upright 1 (9) with two M8 Arc Washers (18)
and two M8X35mm Button Bolts (19).
Finally press the Plastic Caps (13) into the
Side Upright 1 (2).
Do not tighten the locknuts.
6
16
16
16
17
17
14
14
15
15
15
14
17
18
19
5
5
14
14
2
10
14
12
7. Attach three Plastic Protectors (14) to the
Long Cross Bar (5) with three M6X40mm
Button Bolts (16), three M6 Washers(17) and
three M6 Locknuts (15).
Then fix the Side Upright 1 (2) with the M8
Arc Washer (18) and the M8X35mm Button
Bolt (19).
Attach the other three Plastic Protectors (14)
to the Long Cross Bar (5) in the same way.
Then fix the Side Upright 1 (2) in the same
way.
Do not tighten the locknuts.