8
23
Maintenance
When washing machine is frozen
1.Cover stopcock and the universal coupling with hot towel.
2.ake off the inlet pipe, and put it into 50 degree water.
3.Pour into the drum about 2-3L of 50 degree water.
4.Connect inlet pipe, turn on the stopcock and start the washing
machine, please check whether inlet and outlet is normal.
Faucet
Connecting part
Inlet pipe
a.
50 degree
water
c.Pour into the drum
about 2-3L of 50
degree water.
ake off the inlet pipe,
and put it into 50
degree water.
b.
50 degree
water
The Clearance of dewatering-pump filter( Suggest: once/monthly)
1.Press fastener on the pump after dewtering and power off, open the
lid of water-pump filter.(Attention: if hot water inside, please go
ahead after it be cold.)
2.Take off the filter anti-anticlockwise.
3.Wash the filter.
4.Direct at pump and insert the filter, tighten it clockwise and tighten
the lid.
Attention: a. Please tighten the filter well to avoid leak.
b. Please do not clean during operation.
The Drum Clearance (Suggest once/monthly)
After using for a period, some dirt maybe exist. You can clean the
inside and outside of drum by operating the drum procedure.
Attention: please do not put cloths and detergent when clearing the
drum.
the instruction of installation of pipe
Horizontal Adjustment
To avoid noise and vibrate by adjusting washing machine level.
place it at the room corner preferably.
If ground not level, please adjust alignment
pins.(Do not put wood pieces or something
like), please make sure four alignment pins
touch ground tightly, and machine level
completely.
Adjust alignment pins
After adjusting alignment pins.
The diagonal check
Applying force downward on the diagonal of the
washing machine, washing machine should not
shake. (both diagonal need to check, if the
washing machine shake, must readjust
adjustable foot.)
ajustable
foot
up down
locknut
Ma
x
. 1
2
5cm
M
in
.
8
5c
m
Ma
x
. 1
2
5c
m
M
in
.85
c
m
Wash tub
pipe holder
wire harness
To Next Page
Loading...
