7
Fan
· The built-in fan can not only be mainly used for defogging, but also can be used to dissipate the heat
within the product. The speed of fan can be set in the system menu.
· 16-Level User Adjustable speed.
· Press the POWER button to start up/stop the fan for defogging.
HDMI Input
· When enable the HDMI IN mode, the wireless receiver module and the video recording module will be
automatically turned off to save the power.
· It is recognized that the screen and the corresponding resolution information will be automatically
displayed in the supported resolution format.
· The common resolution can be supported (see the specification).
· The wireless receiver module and the video recording module will be automatically turned off in the HDMI
IN mode, in order to save the power.
AV Input
· When enable the AV IN mode . The NTSC and PAL system format can be supported to be automatically
switched.
· The wireless receiver module will be automatically turned off in the AV IN mode to save the power.
AV Output
· The diversity received audio and video signals can be output from the AV Out Port.
· The Earphone port can be connected to the headphones. After the video goggles are powered on each
time, the headphone output volume will be set as the minimum volume, to prevent the excessive volume
from affecting the hearing.
Image Adjustment
· The Brightness, Contrast, Saturation, Hue, Sharpness and other parameters for the image can be adjusted
in the image setting menu, in order to achieve the personalized display effects.
· Press the <OK> button on the function option to enter into the adjustment state; press the <UP/DOWN>
button to adjust the size and display the adjustment effect in real time on the image; press the <ESC>
button to return to the previous menu.
· It is recommended to adjust these parameters on the clear image screen.
OLED Luminance adjust
· The Luminance of the OLED screen and be adjust in the menu (8 stage, default is 5).
· Normally do not set the brightness too high unless the image is dim.
· Due to the OLED's characteristic, excessive brightness may cause a slight brightness drop in local screen.
OLED Sleep
· The sleep mode can be set in the menu( 1minute 3minutes 5 minutes）, default is 3 minutes.
· When sleep mode is activated, the goggles will detect the movement of the goggles (via headtracker
sensor), when the goggles stay still to the preset time , the goggles will switch to sleep mode , the oled
screen will turn off, when the sensor detect the movement of goggles, the goggles will quit sleep mode.
· The sleep mode only turn off the OLED to save the lifetime, the rest functions of goggles is still working
(receiver ,DVR etc).
To Next Page
Loading...