flow. The two (2) o-rings on the steam valve pin should be replaced every six
(6) months.
[INSERT STEAM VALVE DIAGRAM]
Parts and tools:
•
#8 - Part # 5309, Steam Valve Pin O-Rings
•
Flat-head screwdriver
•
3/4” socket wrench
•
Pliers
•
Pick or awl
Procedure:
1. Remove top/side first?
2. While holding the corresponding nut on the machine’s interior with a 3/4”
socket wrench, use a flat-head screwdriver to loosen and remove the
shoulder bolt.
3. Use pliers to remove the steam valve pin (#7).
4. Use a pick or awl to remove the o-rings (#8) from the steam valve pin
and discard them. Put the new o-rings on the pin.
5. Rub Slayer lubricant on the pin and return the pin to the steam valve.
Shoulder Bolt Shims
The shoulder bolt’s shims create a snug fit between the steam actuator hub
and the side panel. Any time the steam actuator is removed, the shims
should be replaced.
[INSERT STEAM SHOULDER DIAGRAM]
Parts and tools:
•
#12 - Part # 5315, Shoulder Bolt Shim
•
Screwdriver
Procedure:
1. Remove the shims from the shoulder bolt and discard them. Place two (2)
new shims on the shoulder bolt.
2. Rub Slayer lubricant inside the steam actuator hub.
3. Attach the steam actuator hub and shoulder bolt to the machine,
tightening with screwdriver. Confirm fit by wiggling the hub. If the hub
does not fit snugly, remove the shoulder bolt and add more shims.
4. Test again and repeat step 3 until hub and panel fit snugly.
Brew Actuator
➡
VIDEO (password: prebrewpressure)
If the brew actuator becomes loose, tighten with the following steps.
Parts and tools:
To Next Page
Loading...
