English
English
T
T
ECHNICAL
ECHNICAL
SPECIFICATIONS
SPECIFICATIONS
Caring for your controller
If your controller is damaged, you should not use it but should return it to where you purchased
it or to Slendertone for replacement or repair. Repairs, service and modifications may not be car-
ried out by anyone other than qualified service personnel authorised by Slendertone.
Access to the interior of the controller is not required for maintenance purposes.
You should report any unexpected operation or event to Slendertone.
Note: Using leak-proof batteries is advised. You should never leave the batteries inside your con-
troller if you do not intend to use it for a long period of time. If you do, the batteries may leak and
damage the controller. You should be aware that some batteries sold as ‘leak-proof’ can still release
some corrosive substances, which may damage the controller. Under no circumstance should
anything other than the correct type of batteries (3 x 1.5V, AAA/LR03) be used with your controller.
You should only insert the batteries in the manner specified in this manual. These can be purchased
from the Slendertone Careline.
Disposing of the gel pads and batteries
Used gel pads and batteries must never be disposed of in a fire but in accordance with your
country’s national laws governing the disposal of such items.
This product is intended for continuous operation i.e. operation in normal use, for an unlimited
period of time, without the specified limits of temperature being exceeded.
Notes:
• The signal gradually increases to a peak intensity level at the start of the contraction phase
(i.e. ramp up) and gradually decreases to nothing at the start of the relaxation phase (i.e. ramp
down). When the symbol is flashing, the stimulus is significantly reduced.
• In accordance with the laws within the member state, safety testing on the device should be car-
ried out every two years.
• In compliance with German law, product safety testing must be conducted every two years by an
authorised test service.
Accessories:
You can purchase all accessories at www.slendertone.com. Under no circumstances should anything
other than Slendertone accessories be used with your Slendertone product (Type 374). Any others
may not be compatible with your product and could degrade the minimum safety levels.
• Set of 12 gel pads - Type 724
18 19
Product Type: 374
Intended Use: Muscle stimulator
Waveform: Symmetrical bi-phasic square waveform when measured into a resistive load.
The patient is the intended operator.
Classification: Internally powered equipment. Type BF applied parts.
This product is not suitable for use in an oxygen-rich environment.
Attention:
This product can deliver currents in excess of 2mA/cm
2
if used with incorrect gel pads.
Environmental Specifications:
Operating Range: Temperature: 5 to 40˚C
Humidity: 15 to 93 % RH (non condensing)
Atmospheric Pressure: 70 to 106kPa
Transport & Storage Range: Temperature: -25 to +70˚ C
Humidity: 10 to 93% RH (non condensing)
Atmospheric Pressure: 50-106kPa
Description of your controller’s symbols:
There are a number of technical markings on your controller. These can be explained as follows:
The controller and headset are manufactured for Bio-Medical Research Ltd, Parkmore
Business Park West, Galway, Ireland.
The controller requires 3 x 1.5V (DC) AAA batteries, type LR03. DC is indicated by the symbol:
This symbol means “Attention, read the accompanying documents”.
This symbol means type BF applied parts (electrodes).
This symbol on your product is to indicate conformity to the requirements of the Med-
ical Device Directive (93/ 42/EEC). 0366 is the number of the notified body (VDE).
SN stands for serial number. Inside the box, on the back of the controller is the serial number specific
to this product. The letter preceding the number indicates the year of manufacture, where ‘S’
denotes 2013, ‘T’ denotes 2014 etc.
0366
To Next Page
Loading...
