This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is
no guarantee that interference will not occur in
a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the
equipment and receiver.
-- Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC
Rules. Operation is subject to the condition that
this device does not cause harmful interference.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
Your wrist watch is a radio transmitter and
receiver. It is designed and manufactured not
to exceed the emission limits for exposure to
radiofrequency (RF) energy set by the Federal
Communications Commission of the U.S.
Government. These limits are part of
comprehensive guidelines and establish
permitted levels of RF energy for the general
population. The guidelines are based on
standards that were developed by
independent scientific organizations through
periodic and thorough evaluation of scientific
studies. The standards include a substantial
safety margin designed to assure the safety of
all persons, regardless of age and health. The
exposure standard for wireless mobile phones
employs a unit of measurement known as the
Specific Absorption Rate, or SAR. The SAR limit
set by the FCC is 1.6 W/kg. * Tests for SAR are
conducted with the phone transmitting at its
highest certified power level in all tested
frequency bands. Although the SAR is
determined at the highest certified power level,
the actual SAR level of the phone while
operating can be well below the maximum
value. This is because the phone is designed to
operate at multiple power levels so as to use
only the power required to reach the network.
In general, the closer you are to a wireless base
station antenna, the lower the power output.
Before a phone model is available for sale to
the public, it must be tested and certified to the
FCC that it does not exceed the limit
established by the government adopted
requirement for safe exposure. The tests are
performed in positions and locations (e.g., at
the ear and worn on the body) as required by
the FCC for each model. The highest SAR value
sobre el cuerpo) según lo solicitado por la FCC
para todos los modelos. El valor más elevado
de SAR para este modelo de teléfono cuando
se lo probó para usarse en la boca es de 0,131
W/Kg y cuando se lo colocó en el cuerpo,
como se describe en el manual del usuario, es
de 0,518 W/Kg. (Las mediciones sobre el cuerpo
son diferentes entre los modelos de teléfonos,
depende de los accesorios disponibles y de los
requisitos de la FCC). Mientras pueden haber
diferencias entre los niveles de SAR de los
distintos teléfonos y en distintas ubicaciones,
todos cumplen con los requisitos del gobierno
en cuanto a una exposición segura. La FCC ha
otorgado una autorización del equipo para
este modelo de teléfono con todos los niveles
informados de SAR evaluados, en cumplimiento
con las pautas de exposición de RF de la FCC.
La información de la SAR en este modelo de
teléfono está archivado en la FCC y se puede
encontrar en la sección Display Grant en
http://www.fcc.gov/ oet/fccid luego de buscar
en FCC ID: 2AJVKSW200
Se puede encontrar información adicional
acerca de las tasas de absorción específicas
(SAR) en la página web de Cellular
Telecommunications Industry Association (CTIA)
en http://www.wow-com.com. * En los Estados
Unidos y en Canadá, el límite de la SAR para
teléfonos móviles usados por el público es de
1,6 watts/kg (W/kg) promediado sobre un
gramo de tejido. La norma incorpora un
margen sustancial de seguridad para ofrecer
protección adicional para el público y para
considerar cualquier variación en las medidas.
To Next Page
Loading...
