The card slot dust cover included with
the base chassis hardware kit installs on
the outside above PCIe card slot cutouts
using 2x M3 x 6mm PAN HEAD screws.
Additional Hardware:
5x M3 x 6mm PAN HEAD for Cerberus
8x M3 x 6mm PAN HEAD for Cerberus
X PCIe card mounting are shown.
CARD SLOT DUST COVER / HANDLE BRACKET
HANDLE KIT BRACKET mounts as
shown with 4x
M3 x 5mm FLAT
HEAD
screws. Attach top panel and
then install handle with 2x
M3 x
25mm SOCKET CAP
. The 4x holes
around cutout are for mounting a
120mm or 140mm fan with 120mm
spacing.
To Next Page
Loading...