• Max loading is 113 kgs (250 LBS)
13.Please stop machine after 1 hour’s running to avoid any damage to the motherboard due to overheating.
14.Disconnect the plug when Slim Tread™ won’t be used for a long time. Leaving plugged in full time may cause some potential
dangers for Slim Tread™ or for you.
15.Use Slim Tread™ properly，don’t use with sports injury. Do warm up exercises before walking/running. Do not do over excessive
exercise.
16.If there are any emergency situations or speed is out of control, jump off of the Slim Tread™ from left or right sides, and unplug it.
17.Please use original power cord if the previous power cord is broken. Contact retailer for buying original power cord or other parts.
18.The power cord should never be extended. Do not replace the plug by yourself. Do not place any object on plug and wire. Do not
use power strip. Connect to a wall socket directly only.
IMPORTANT NOTICE:
1.Use a qualified wall socket, and make sure plug is tight. If plug and socket is incompatible, please change to the correct socket to
avoid electrical shock.
2.Do not let cable contact any other parts such as cylinder, running belt etc. Damaged plug should not be used.
3.Do not use outdoors, in high humidity, high light, or direct sun exposure.
4.Do not step on display area.
5.Do not overload the Slim Tread™.
6.Do not disassemble any parts forcibly.
7.Do not cut power off while using.
8.Please cut power off and make sure there is no moisture before daily cleaning and maintaining Slim Tread™.
MAINTENANCE:
Maintenance of running belt
Running board and running belt for Slim Tread™ is of premium quality. Lubrication is advised every 10-15 times of use.
The friction coefficient is much less than a traditional treadmill. Using lubricating oil keeps Slim Tread™ in the best condition. Please
check every 30 hours or 30 days use by touching the inside of running belt. Touch the inside part of running belt as far as possible
from the backside of Slim Tread™, if it is lubricated, then there is no need to add lubricating oil. If it is very dry, please add
lubricating oil as required.
To Next Page
Loading...