HOW TO INFLATE TIRES:
1. Attach air hose to tire by fully screwing the
connector onto the tire valve.
2. Plug power cord into power accessory outlet or
leave unplugged to run from battery.
NOTE: The unit will not run unless the gauge is
turned
on
b
y
pr
essing
the
“
set”
button.
3
. To
set
the
Inflate-Right™
system,
pr
ess
either
arr
ow
button under the display for 3 seconds until the
tar
get
pr
essure
blinks.
4.
Use
the
up
and
do
wn
arr
ow
buttons
to
r
each
y
our
tar
get
pr
essure.
The
inflator
will
stor
e
this
pr
essure
automatically after a few seconds.
5. To inflate, press the button with the tire symbol.
Once
y
our
tar
get
pr
essure
is
r
eached,
the
inflator
will shut off. The inflator can be manually shut off
by pressing the tire symbol button again.
6.
Unplug
po
wer
cor
d
(if
necessar
y)
and
disconnect
the
air
hose.
NOTE: Correct tire pressure can be found in vehicle’s
o
wner manual or driver’s side door jamb.
T
O TOGGLE PRESSURE UNITS (PSI/kPa/BAR):
Press
the
“S
et”
button
at
the
base
of
the
gauge.
HOLD FOR 3 SECONDS
TARGET PRESSURE
To Next Page
Loading...
