Slime 50139 - Tire Repair Procedures; Air + Sealant Tire Repair; Pressure Release Function; Sealant Cartridge Replacement

The PRESSURE RELEASE ensures optimum PSI pressure. Push the area to
deflate the tire if it has been overinflated, or if there is too much air prior to
inflation. Check the gauge for the desired PSI level.
FLAT TIRE REPAIR (AIR + SEALANT) INSTRUCTIONS
A
I
R
O
N
L
Y
A
I
R
+
S
E
A
L
A
N
T
1
3
4
12v
3
4
12v
12V
2.0 MI/3.2 KM
PSI
BAR/KPA
1. Select AIR + SEALANT. NOTE: Lay Flat Tire Repair Kit on the ground facing upward.
2. Screw AIR/SEALANT hose onto tire’s valve stem.
3. Plug inflator into 12 volt accessory power outlet.
4. Push ON/OFF button to turn system on. Fill to desired pressure.* Press ON/OFF
button to turn system off and check tire pressure. Once correct tire pressure has
been achieved, disconnect AIR/SEALANT hose and power plug.
5. Drive 2 miles (3.2km) with speeds less than 25 miles per hour to disperse sealant
throughout the tire, allowing it to seek out and seal the puncture. Recheck tire
pressure to verify that the puncture has been sealed.
*NOTE: Correct tire pressure can be found in vehicle owner's manual or on driver's
side door jamb.
Check your tire warranty prior to installation of this product.
NOTE: Engine should be running while using this inflator. See Warning Section for
further details. Seals punctures up to 1/4 in. (6mm) in tread area for flat tire repair.
PRESSURE RELEASE
SEALANT CARTRIDGE REMOVAL INSTRUCTIONS
1. Unwrap AIR/SEALANT hose.
2. Lift off cartridge cover.
3. Rotate cartridge to upright position.
4. Pull cartridge out horizontally.