Slime PRO POWER - Technical Specifications

Ensure that the vehicle is outside, or in an open, well-ventilated area and NOT INSIDE A
CONFINED AREA, SUCH AS A GARAGE as bodily injury or asphyxiation resulting in death
could occur. Always operate the inator in a well-ventilated area free of combustible
materials, gasoline, or solvent vapors. Always set parking/emergency brake and ensure
vehicle is in Park (or neutral if equipped with manual transmission).
CAUTION: HOT • DO NOT HOLD IN HAND WHILE OPERATING
NOTICE: ENGINE SHOULD BE RUNNING WHILE USING THIS INFLATOR
It is recommended that you operate your inator with your vehicle’s engine running to
achieve the optimal inator performance. Never start the vehicle while the inator is
connected to the baery.
• Do not aempt to disassemble inator.
• No user serviceable parts inside.
• Keep inator out of reach of children.
• Place inator on a hard, clean surface.
• Ensure air hose chuck touches the core of the valve stem for proper ination.
• DO NOT use inator continuously for more than 10 minutes. Allow unit to cool approximately 25 minutes
between uses. Do not leave inator unaended.
• ALWAYS use a pressure gauge to check tire pressure. DO NOT over-inate.
• So inatables (i.e. ras, balls, etc.) may not have recommended pressure markings. Be careful not to
inate items beyond their capacity.
• While operating, never block the inator input or output.
• Make sure connections and terminals are free of corrosion, debris, etc.
• To reduce risk of electrical shock or electrocution, do not disassemble the tire inator.
• Do not use this product in an area where it can fall into liquids or bodies of water.
• The tire inator is not intended to be hard-wired to your vehicle’s 12V DC system.
• The 12V direct connect clips should be stored in secure manner when not in use; do not leave 12V direct
connect clips connected to baery while vehicle is in motion.
• For use with 12-volt DC baeries.
VEHICLE EXHAUST WITHOUT PROPER VENTILATION IS
EXTREMELY DANGEROUS. ALWAYS ALLOW FOR PROPER
VENTILATION.
TECH SPECS
TIRE INFLATION TIME
CFM (LPM)
IN-LINE DIAL GAUGE
COIL AIR HOSE LENGTH
POWER CORD LENGTH
POWER SOURCE
TOTAL REACH
* (0-35 PSI, Standard Tire: P195/65 R15)
1.5 min*
2.5 CFM (70.8 LPM) @ 0 PSI
PSI 0-150, BAR 0-10
22 . (6.7 m)
8 . (2.4 m)
Direct connect to baery
33 . (10 m)