Sloan OPTIMA I.Q. EAF-100 Series User Manual (English)

To Next Page

Code No. 0816542

Rev. 3 (02/11)

SPOUT

TEMPERED

SUPPLY

O-RING

GASKET

RETAINER

NUT

1-3/16” (30 mm)

MIN. DIA. HOLE

REQUIRED ‡

1-1/2” (38 mm)

MAX. DECK

THICKNESS ‡

If a connection to separate hot

and cold water supplies is desired,

then a Bak-Chek

tee fitting (not

supplied) must be used prior to

connecting to the faucet.

13” (330 mm)

LONG FLEX HOSE

HOT

SUPPLY

COLD

SUPPLY

MIXING VALVE (Can Be

Set and Removed)

13” (330 mm)

LONG FLEX

HOSES

MODELS EAF-100/150

1.5 gpm (5.7 Lpm) Max. Flow Aerator

Faucets with Single Line Water Supply

MODELS EAF-100/150-ISM

MODELS EAF-100/150-ISM-DPU-IC

1.5 gpm (5.7 Lpm) Max. Flow Aerator

Faucets with Hot and Cold Water Supply

INSTALLATION INSTRUCTIONS FOR OPTIMA I.Q.

ELECTRONIC SENSOR ACTIVATED LAVATORY FAUCETS

LIMITED WARRANTY

Sloan Valve Company warrants its Optima EAF-100 and EAF-150 Series Electronic Hand Washing Faucets to be made of first class materials, free from defects of material or workmanship under normal use and to perform the service for which

they are intended in a thoroughly reliable and efficient manner when properly installed and serviced, for a period of three years from date of purchase. During this period, Sloan Valve Company will, at its option, repair or replace any part or parts

hich prove to be thus defective if returned to Sloan Valve Company, at customer’s cost, and this shall be the sole remedy available under this warranty. No claims will be allowed for labor, transportation or other incidental costs. This warranty

extends only to persons or organizations who purchase Sloan Valve Company’s products directly from Sloan Valve Company for purpose of resale. This warranty does not cover the life of the battery.

THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF. IN NO EVENT IS SLOAN VALVE COMPANY RESPONSIBLE FOR ANY CONSEQUENTIAL DAMAGES OF ANY MEASURE WHATSOEVER.

FAUCET VARIATIONS

SPOUT

O-RING

GASKET

RETAINER

NUT

1-3/16” (30 mm)

MIN. DIA. HOLE

REQUIRED ‡

1-1/2” (38 mm)

MAX. DECK

THICKNESS ‡

EAF-100 Series

Adapter Powered, Sensor

Activated, Lavatory Faucets

EAF-150 Series

Battery Powered, Sensor

Activated, Lavatory Faucets

6-7/8”

(175 mm)

24º

2-3/8 (60 mm)

2-3/4 (70 mm)

POP UP — MODELS EAF-100/150-ISM-DPU-IC

ONLY

2-3/8

(60 mm)

‡ When installing the Faucet on a three (3) hole

sink, make sure that the center hole is large

enough to accommodate the Faucet shank. A 1-

3/16" (30 mm) minimum diameter hole is

required. NOTE: A 1-7/32” (31 mm) Diameter

hole is required if the deck is greater than 1/2”

(13 mm) thick.

5-9/16”

(142 mm)

-ISM

Integral Spout Mixer

-IC

-Click

Feature

-DPU

rain Pop Up

-P

Plug-in Transformer/Adapter

(EAF-100 Series)

-LT

Less Transformer/Adapter

(EAF-100 Series)

PRIOR TO INSTALLATION

Prior to installing the Sloan Optima EAF-100/150 Series Faucets, install the

items listed below. Also, refer to rough-in illustrations.

• Lavatory/sink

• Drain line

• Hot and cold water supply lines or pre-tempered water supply line.

Trim Plates

When the EAF Faucet is installed on a sink that has three (3) hole punchings, a

Trim Plate should be used.

Trim Plates must be specified and ordered

separately.

ETF-607-A

Trim Plate for 4” (102 mm) Centerset Sink

ETF-608-A

Trim Plate for 8” (203 mm) Centerset Sink

Important:

•

ALL PLUMBING SHOULD BE INSTALLED IN ACCORDANCE WITH APPLICABLE

CODES AND REGULATIONS.

•

FLUSH ALL WATER LINES PRIOR TO MAKING CONNECTIONS.

•

KEEP THREAD SEALANT OUT OF YOUR WATERWAY TO PREVENT

COMPONENT PART DAMAGE! DO NOT USE ANY SEALANT ON

COMPRESSION FITTINGS.

TOOLS REQUIRED FOR INSTALLATION

• 13 mm open end wrench for male end of flex hose

• 13 mm open end wrench or nut driver for faucet retainer nut

• 5/8” open end wrench for female end of flex hose (US)

• 3/4” open end wrench for female end of flex hose (International)

FAUCET ROUGH-IN

Need help?

Do you have a question about the Sloan OPTIMA I.Q. EAF-100 Series and is the answer not in the manual?

Sloan OPTIMA I.Q. EAF-100 Series Specifications

General

Category	Kitchen & Bath Fixtures
Power Source	Battery or Hardwired
Material	Brass
Model	EAF-100 Series
Type	Electronic Faucet
Flow Rate	0.5 GPM (1.9 LPM)
Finish	Chrome
Operating Pressure	20 - 80 PSI