Need help?Do you have a question about the smaco S300 and is the answer not in the manual?
Maximum pressure is 3000psi/200bar/20Mpa.
Check parts, remove protection sleeve, check thread, tighten valve for inflation.
Check for leaks, use compressed air, stop at 3000psi, use pumps with oil-water separator.
Tighten pressure gauge and inflation plug with a wrench to fix leaks.
Rearrange gasket and accessories, align valve, and tighten to fix leaks.
Clean/replace O-ring at inflation plug port, re-install, and tighten to fix leaks.
Max pressure 20MPa; use only human-breathing compressed air.
Maximum pressure is 3000psi/200bar/20Mpa.
Check parts, remove protection sleeve, check thread, tighten valve for inflation.
Check for leaks, use compressed air, stop at 3000psi, use pumps with oil-water separator.
Tighten pressure gauge and inflation plug with a wrench to fix leaks.
Rearrange gasket and accessories, align valve, and tighten to fix leaks.
Clean/replace O-ring at inflation plug port, re-install, and tighten to fix leaks.
Max pressure 20MPa; use only human-breathing compressed air.
General| Brand | smaco |
|---|---|
| Model | S300 |
| Category | Diving Instrument |
| Language | English |
To Next Page