SMART 2016 fortwo - Brake Lamps

X
Insert the bulb holder into side turn signal
lamp ; and turn it a quarter turn clock-
wise.
X
Insert side turn signal lamp ;.
Changing the rear bulbs
Tail lamp
X
Switch off the lights.
X
To remove: open the upper and lower tail-
gate (
Y page 58).
X
Remove two screws : on the tail lamp using
a suitable slotted screwdriver.
X
Carefully take out the lamp.
X
To release the connector: insert a suitable
slotted screwdriver under the plastic
hanger, lift a small plastic piece upwards
and remove the connector.
Bulb holder
:
Tail lamp/brake lamp/side marker lamps
(only vehicles without partial LEDs)
;
Turn signal
=
Backup lamp
?
Rear foglamp (vehicles without partial
LEDs)
X
Unclip four bulb holder tabs A and care-
fully remove the bulb holder.
X
Remove the corresponding bulb from the
bulb holder.
X
Insert the new bulb.
X
Re-install bulb holder.
Four bulb holder tabs A must audibly
engage.
X
Insert the connector.
X
Insert the lamp again.
X
Tighten the two screws : on the tail lamp
again.
License plate lamp
X
To remove: release catch : of the lamp lens
using a suitable tool.
X
Remove the lamp lens.
X
Remove bulb : from the bulb holder.
X
Insert the new bulb.
X
Re-insert the lamp lens into the license
plate lamp.
74
Replacing bulbs
>> Lights and windshield wipers.