Always comply with the manufacturer's
installation and operating instructions for
the child restraint system used.
Suitability of the seats for child
restraint systems
Notes on attaching suitable child
restraint systems
Only child restraint systems that meet the
following ECE standards are permitted for
use in the vehicle:
R
ECE R44
R
ECE R129 (i‑Size child restraint systems)
Only suitable for use in the vehicles speci-
fied which are equipped with three-point
seat belts approved in accordance with ECE
Regulation No.16 or similar standards.
Label for an ECE R44 compliant child restraint
system
Label for an ECE R129 compliant child restraint
system
ISOFIX or i-Size child restraint systems in
the following "Universal" category may be
used on seats marked U, UF, IUF or i-U in
accordance with the tables on the suitability
of the seats for attaching child restraint sys-
tems.
Semi-universal child restraint systems are
indicated by the text "Semi-universal" on the
approval label. Use is only permitted if the
vehicle and the seat are listed in the child
restraint system manufacturer's vehicle
model list.
Suitability of the seats for attaching belt-secured child restraint systems
Observe the following notes:
R
for certain child restraint systems of weight category II or III there may be limitations for
the maximum size setting, e.g. due to possible contact with the roof.
R
the child restraint system must not touch the roof or be subjected to a load by the head
restraint.
R
observe the manufacturer's installation instructions for the child restraint system.
Legend for the table:
R
X: not suitable for children of this weight category.
R
U: suitable for child restraint systems in the "Universal" category that are approved for use
in this weight category.
Children in the vehicle
47
>> Safety.
Z
To Next Page
Loading...
Need help?
General
