- In the parcel shelf in the rear;
- In the front bumper( non-material face), please ensure the device cannot
get wet;
- Under the wiper version (non-metal), please ensure the device cannot
get wet;
Notice: If the windshield is pasted with metal thermal-protective coating,
it may affect the performance of the device. In this case, please change
the installation place after consulting the professional.
5)Non Covert Installation,
Firstly fix the device on the dash board below windshield.
7. Cautions of device wiring
7.1 The standard voltage is 9V-36V, the red wire is the positive, the
black wire is the negative.
7.2 Please connect the black wire to ground.
7.3 After connecting the power cord, run the power cord plug to the
device. After installation, supply power to device.
7.4 Covert installation: car battery cord is standard, with 2A FUSE for
short-circuit over current protection.
7.5 Non covert installation: cigar lighter cord is optional, with 2A FUSE
for short-circuit over current protection. Please contact your dealer if this
mode is needed.
To Next Page
Loading...