SMART LiFePO4 Deep Cycle - Charging in Safe Mode: With a Charged Battery

9
WITH A CHARGED BATTERY
If you have a charged battery
(E.G. car battery) and jumper
cables, follow the below steps in
sequence to bring your Lithium
battery out of safe mode.
1. Disconnect all loads/inputs from
the Lithium battery.
2. Connect the Lithium battery in
parallel to a dierent battery
(battery number 2).
3. Cross reference the voltage on
each battery now they are in
parallel – they should both now
read a similar voltage.
4. Connect an AC to DC charger
to the Lithium battery and
allow it to begin charging. We
recommend a 20 amp or higher
charger.
5. When the charger begins to
charge the Lithium battery,
disconnect battery number 2.
6. The charger should continue
to charge the Lithium battery,
bringing it out of safe mode.
7. Allow the charger to fully charge
the battery.
21
2
1
21
21
CHARGING A LITHIUM DEEP CYCLE BATTERY IN
SAFE MODE (LOW VOLTAGE)
1
2
3
4
5
6
7