SMART LiFePO4 Deep Cycle - Charging in Safe Mode: With a Jump Starter

10
CHARGING A LITHIUM DEEP CYCLE BATTERY IN
SAFE MODE (LOW VOLTAGE)
WITH A JUMP STARTER
If you have a portable Jump
Starter, follow the below steps in
sequence to bring your Lithium
battery out of safe (low voltage)
mode.
1. Disconnect all loads/inputs from
the Lithium battery.
2. Connect the Jump Starter
cables to the battery (Positive to
Positive, Negative to Negative)
3. Connect an AC to DC charger
to the Lithium battery. We
recommend a 20 amp or higher
charger.
4. Activate the jump starter to
supply power to the Lithium
battery. The charger will now
detect the battery and begin to
charge.
5. When the charger begins to
charge the Lithium battery,
disconnect the Jump Starter
from the battery.
6. The charger should continue
to charge the Lithium battery,
bringing it out of safe mode.
7. Allow the charger to fully charge
the battery.
1
2
3
4
5
6
7