14
MEMORY TEST
The Memory Test command performs a diagnostic on the audio memory testing for errors. The Memory Test
command erases all messages and resets the unit to the factory default settings. If the command is correctly
entered the user hears the system busy signal for a period of time while the test is performed, followed by the
success beep or error tone depending on the outcome of the test. After the command has completed the unit
returns to command mode ready to enter the next command.
Syntax...
* 8 1 # Memory Test
RESTORE DEFAULT CONFIGURATION
The Restore Default Configuration command restores the unit to the factory defaults. This command erases all
messages and brings the system to a fresh state which provides a good starting point for system configuration. If
the command is correctly entered the user hears the system busy signal for a period of time while the units
memory is erased, followed by the success beep, returning to command mode ready to enter the next command.
See appendix C for a full listing of the default values. All messages are gone, and require re-recording.
Syntax...
* 9 9 # Restore default configuration
APPENDIX A
MESSAGE CONFIGURATION
The following table shows the lengths for each available message.
16 Minute Memory Greeting Message 45 seconds
3 Information Messages 45 seconds each
Movie List Message 60 seconds
24 Screen Messages 30 seconds each
APPENDIX B
COMMAND SUMMARY
NAME SYNTAX RANGE DESCRIPTION
Rings * 1 1 X X # 01 - 15 Sets number of rings to answer.
Message Record * 5 0 X X # None Records Messages
01-24 = Selections, 31 = Greeting,
32 = Selection List, 33-35 = Info.
Message Review * 6 0 X X # None Reviews Messages
To Next Page
Loading...