7
INSTALLATION
GENERAL INFORMATION
Install the MovieTimeS in close proximity to the telephone line which the unit is to answer and within 6’ of a
117VAC wall outlet. The MovieTimeS is designed to mount on a wall, shelf or other flat surface. When
mounting the unit, be sure to leave clearance at the rear of the unit for connection accessibility.
STANDARD INSTALLATION
Install the MovieTimeS directly on the incoming telephone line at a point before the line is split into multiple
extension lines. If you fail to do so, all of the extension phones ring each incoming call and only calls received
by the unit are transferred to the phone attached directly to the unit. If you cannot locate the point at which your
telephone line is split into extensions or if you are unable to tap into the line at this point, contact your telephone
company.
CONNECT TO TELCO
OPTIONAL PHONE
CONNECT TO 12VAC
LINE 1
LINE 2
12VAC
MADE IN USA
Follow steps 1-6 for standard installation:
1. Attach one end of the modular telephone cable (included) to the TELCO jack of the MovieTimeS.
2. Attach the other end of the modular telephone cable to the wall jack of the line intended for use.
3. Connect one end of another modular telephone cable to the PHONE jack of the MovieTimeS.
4. Connect the other end of the modular telephone cable an optional telephone.
NOTE: Repeat steps 1- 4 for the second line
5. Attach the included power supply to the 12VAC jack of the MovieTimeS.
6. Plug the other end of the power supply into the 117VAC wall outlet.
NOTE: Applying power to the MovieTimeS disrupts any calls in progress on the installed lines
KSU / PBX INSTALLATION.
To Next Page
Loading...