8
The MovieTimeS must be installed on the phone company side of your phone system. If installed directly to an
unsuitable extension line the phone system or the MovieTimeS may be damaged. If you are not familiar with
how your phone system is installed, or do not know which lines go directly to your phone company please find a
qualified person to perform the installation.
CONNECT TO 12VAC
B O X
IN TE R FAC E
LINE
COMPANY
PHONE
SYSTEM
PHONE
PBX OR KSU
LINE 1
LINE 2
LINE 3
LINE 4
EXT. 1
EXT. 2
EXT. 3
EXT. 4
INCOMING LINES
LINE 1
LINE 2
12VAC
MADE IN USA
Follow steps 1- 6 for KSU/PBX installation:
1. From your telephone system input, disconnect the telephone line for which the MovieTimeS is to answer.
2. Attach the disconnected line to the TELCO jack of the MovieTimeS.
3. Connect one end of the included modular telephone cable to the PHONE connector of the MovieTimeS.
4. Connect the other end of the modular telephone cable to the input of your phone system, where you made
the original disconnection.
NOTE: Repeat steps 1-4 for the second line
5. Attach the included power supply to the 12VAC jack of the MovieTimeS.
6. Plug the other end of the power supply into the 117VAC wall outlet.
NOTE: Applying power to the MovieTimeS disrupts any calls in progress on the installed lines.
To Next Page
Loading...