SMART SENDO - Installing; Changing the Batteries

About 1 cm
Installing / Changing the Batteries
Slide the battery cover as shown to remove it
from the device.
Insert two AAA / LR03 size batteries in the battery
compartment, with positive (+) and negative (-)
terminals matching those indicated on the battery
compartment.
Slide the battery cover back on the device.
Use only AAA/LR03 batteries.
Fastening the Cu
Wrap the cu around your wrist about 1 cm above your hand as shown in
the gure at the right.
The monitor should be placed on inner side of the arm.
Fasten the cu
tightly using the
Velcro strip.
Note: For proper
measurements,
fasten the cu tightly
and measure on a
bare wrist.
1
1
2
2
3
3