USER GUIDE PAGE 11GSK-6000
JUMP START YOUR VEHICLE USING THE GSK-6000
1. Identify the polarity of the battery posts. The positive battery
terminal is typically marked by these letters or symbols
(POS,P,+). The negative battery terminal is typically marked by
these letters or symbols (NEG,N,-).
2. Do not make any connections to the carburetor, fuel lines, or
thin metal parts.
3. Identify if you have a negative or positive grounded vehicle.
4. This can be done by identifying which battery post (NEG or
POS) is connected to the chassis.
5. For a negative grounded vehicle (most common): connect
the RED POSITIVE jumper clamp rst to the positive battery
terminal, then connect the BLACK NEGATIVE jumper clamp to
the negative battery terminal or vehicle chassis.
6. For a positive grounded vehicle (very uncommon): connect the
BLACK NEGATIVE jumper clamp rst to the negative battery
terminal, then connect the RED POSITIVE jumper clamp to the
positive battery terminal or vehicle chassis.
7. When disconnecting, disconnect in the reverse sequence,
removing the negative rst (or positive rst for positive ground
systems).
ATTACHING THE BATTERY CLAMPS
JUMP STARTING PROCEDURE
1. This unit is only for emergency use, not for frequent commercial
use! The ENGINE START socket is ALWAYS activated! Do not
attempt to jumpstart your vehicle when the GSK-6000 Power Bank
battery capacity is below 30%.
2. Turn off the vehicle ignition and all accessories (radios, lights, air
conditioners, etc.), and disconnect electronic devices.
3. Connect the jumper clamps to the correct polarity battery terminals.
To Next Page
Loading...
