Smartech TECH-5000P - Jump Starting Your Vehicle; Connect to Battery

USER’S MANUAL PAGE 9TECH-5000P
JUMP START YOUR VEHICLE BATTERY USING THE
TECH-5000P POWER BANK
CONNECT TO BATTERY
1. Identify polarity of battery posts. The positive battery terminal
is typically marked by these letters or symbol (POS,P,+). The
negative battery terminal is typically marked by these letters or
symbol (NEG,N,-).
2. Do not make any connections to the carburetor, fuel lines, or
thin metal parts.
3. Identify if you have a negative or positive grounded vehicle.
This can be done by identifying which battery post (NEG or
POS) is connected to the chassis.
4. For a negative grounded vehicle (most common): connect
the RED POSITIVE jumper clamp rst to the positive battery
terminal, then connect the BLACK NEGATIVE jumper clamp to
the negative battery terminal or vehicle chassis.
5. For a positive grounded vehicle (very uncommon): connect the
BLACK NEGATIVE jumper clamp rst to the negative battery
terminal, then connect the RED POSITIVE jumper clamp to the
positive battery terminal or vehicle chassis.
6. When disconnecting, disconnect in the reverse sequence,
removing the negative rst (or positive rst for positive ground
systems).