8
Chemicals
• Avoid contact with hot fuel, oil, exhaust fumes, and hot solid surfaces.
• Avoid body contact with fuels, oils, and lubricants used in the generator. If
swallowed, seek medical treatment immediately. Do not induce vomiting if fuel is
swallowed. For skin contact, immediately wash with soap and water. For eye
contact, immediately flush eyes with clean water and seek medical attention.
Noise
Prolonged exposure to noise levels above 85dBA is hazardous to hearing.
Always wear ANSI approved ear protection when operating or working around the
Generator when it is running.
Extension Cords
If an extension cord (not included) is used, make sure to use only UL approved cords
having the correct gauge and length according to the following table:
Nameplate Amps Cord Lengths
(@full load) 0’-50’ 50’-100’ 100’-150’ 150’-200’
0-5 16 16 12 12
5.1-8 16 14 10 -
8.1-12 14 12 - -
12.1-15 12 10 - -
15-20 10 10 - -
Note:
Prior to powering tools and equipment, make sure the generator’s rated
voltage, wattage, and amperage capacity is adequate to supply all
electrical loads that the unit will power. If powering exceeds the
generator’s capacity, it may be necessary to group one or more of the
tools and/or equipment for connection to a separate generator.
WARNING!
This machine cannot be connected to a building’s electrical system as a
standby backup power. Improper connections can allow electrical current
from the generator to back feed into the utility lines. Such back feed may
electrocute utility company workers or others who contact the lines during
a power outage, and when utility power is restored, the generator may
explode, burn, or cause fires in the building’s electrical systems.
To Next Page
