Other SwitchLinc Models
Our powerline controlled SwitchLincs give you the ability to remotely control the switch from
anywhere in your home or from anywhere in the world! They use the popular X10 powerline
control system to remotely turn on, dim or turn off lights and most other loads. We offer sever-
al models all matching the SwitchLinc Deluxe Dimmer appearance.
SwitchLinc
2-WWay
Dimmer (600 Watt) #2380W/I - (White or Ivory)
SwitchLinc
2-WWay
Dimmer (1,000 Watt) 2381W/I - (White or Ivory)
SwitchLinc Relay
2-WWay
(15 Amps) #23883W/I - (White or Ivory)
SwitchLinc
PLC
Dimmer (600 Watt) #2384W/I - (White or Ivory)
SwitchLinc Relay
PLC
(15 Amps) #23885W/I - (White or Ivory)
SwitchLinc
Plus
Dimmer (600 Watt) #2386W/I - (White or Ivory)
SwitchLinc Multi-Way Companion Switch #2382W/I - (White or Ivory)
(Note: 2382 does not have LED brightness bar.)
SwitchLinc
RX
Plus
Dimmer (600 Watt) #2386W2 White or #2386I2 Ivory
SwitchLinc
RX
PLC
Dimmer (600 Watt) #2384W2 White or #2384I2 Ivory
SwitchLinc
RX
Dimmer (600 Watt) 2387W2 White or 2387I2 Ivory)
XX
XX
3
CAUTION!!
Read and understand these instructions before installing. This device is intended for installa-
tion in accordance with the National Electric Code and local regulations in the United States,
or the Canadian Electrical Code and local regulations in Canada. To reduce the risk of over-
heating and possible damage to other equipment, do not install a SwitchLinc to control a
receptacle or fluorescent lighting fixture. For indoor use only. Connect only copper or copper-
clad wire to this device. Before installing, disconnect power at circuit breaker or remove fuse
to avoid shock or damage to the control. It is recommended that a qualified electrician per-
form this installation. Retain these instructions for future reference. Dimming an inductive
load (such as a ceiling fan) below the minimum voltage set by the manufacturer of the load
device could cause damage to the load device from overheating. If the manufacturer of the
load device does not recommend dimming, DO NOT use SwitchLinc Deluxe Dimmer with that
device (use SwitchLinc Relay 2-Way #23883W/I or PLC #23855W/I). USER ASSUMES ALL
RISKS ASSOCIATED WITH DIMMING AN INDUCTIVE LOAD.
Gradateurs commandant une lampe a filament de tungstene - afin de reduire le risque of sur-
chauffee et la possibilite d’endommagement a d’autres materiels, ne pas installer pour com-
mander une prise, un appareil a monteur, une lampe uorescente ou un appareil alimente par
un transformateur.
To Next Page
Loading...
