SmartLock VISION User Manual

VISION TECHNICAL MANUAL
Default codes (change default codes)
Setup (Master) 5-0-5-0-5-0-5-0
Service not installed
Manager 1-2-3-4-5-6
Users (1-9) not installed
Open the lock
•
Enter the code and open within 4 seconds.
•
If time delay is set wait for counting: an acoustic signal indicates open window.
•
Enter the code and open within 4 seconds.
Open the lock with time delay override
•
Enter override user (9) code.
•
Enter second code and open within 4 seconds.
If lock is already counting time delay enter override user (9) code to immediately open.
Change code (door open)
•
Press and hold 0 until double beep: enter old code.
•
Enter and confirm new code.
Install a user
•
Press and hold 1 until double beep: enter Manager code.
•
Enter user ID (1-9).
•
Enter and confirm new user code.
To install Manager enter the function with Service code.
Users management
•
Press and hold 2 until double beep: enter Manager code.
•
Press P to scroll users list and check their status.
•
Press 1 to install a user: enter and confirm user code.
•
Press 2 to disable/enable a user.
•
Press 3 to delete a user.
•
Press OK to confirm and exit.
Delete a user
•
Press and hold 3 until double beep: enter Manager code.
•
Enter user ID (1-9).
To delete Manager enter the function with Service code.
Test function
•
Press and hold 5 until double beep.
•
Enter the sequence: 1-2-3-4-5-6-7-8-9-0.
•
Double beep: key properly working. Long beep: key malfunction.
If lock and keypad don’t communicate display shows the message: NO ANSWER.
of 1 2
OPEN
LOCK
CODE
o o o o o o
INSTALL
o o o o o o
CHANGE
o o o o o o
ID= 1
ID= 2
ID = 3
DELETE
o o o o o o
TEST

SmartLock VISION Specifications

General

Brand	SmartLock
Model	VISION
Category	Locks
Language	English

Summary

Lock Operation

Open the Lock

Instructions for opening the lock with a code entry, including handling time delays.

Override Time Delay

Procedure to immediately open the lock when a time delay is active using an override code.

User and Code Management

Change Code

Steps to change the existing door code to a new one.

Install User

Process for installing a new user code via Manager code authentication.

Manage Users

Functions for managing users including installation, disabling, enabling, and deletion.

Delete User

Procedure to remove a user from the system using Manager code.

System Functions

Test Function

Procedure to test lock functionality and identify potential malfunctions.

Advanced Setup and Configuration

Change Setup Code

Instructions for changing the Master Setup code.

Service Code Management

Procedures for installing and deleting Service codes.

Reset Lock

Steps to reset the lock to its default or pre-setup mode.

Pre-Setup Mode

Information on accessing the lock in pre-setup mode and its default code.

Lock Setup Options

Details on configuring lock settings like code changes, configuration, time delays, and code length.

Time Delay Settings

Configuration for opening delay and time delay values.

Language and Firmware

Procedure to change the display language and check firmware version.