Please read all instructions before use.
Power ON/OFF
Fan Adjust Button
Mode Button
Scroll Up
Scroll Down
USER MANUAL
SMARTVENT LITE CONTROLLER
Distributed by Simx Limited
PO Box 14 347, Panmure, Auckland, NZ.
Technical Support (09) 259 1662 | e: sales@simx.co.nz | w: www.simx.co.nz
We reserve the right to change specification without prior warning.
Automated Touch Screen Overview
The large screen is designed to measure the indoor and roof air temperature
using a high precision built-in sensor.
Take control over the ventilation speed and temperature settings.
PUB1407 1805
Configuration Setup Menu
Programming Mode:
• To calibrate your controller to operate correctly you need to enter the
programming mode:
• Turn off your controller with the Power OFF button.
• Press and hold the Mode and Fan icons for 5 seconds then release.
• To change other modes, press the Mode button again and step through to the
different Mode option(s) as listed below (the numbers appear in the top right
corner of the display).
• The central display is the value set for that particular Mode.
Mode Description Default
1
Room Temperature correction: to correct displayed room
Temperature.
-1.0
2
Roof Maximum Temperature: when roof is hotter than this
temperature the fan will slow down or stop (see Mode 5).
35
3
Roof Minimum Temperature: when roof is colder than this
temperature the fan will slow down or stop (see Mode 5).
5
4
Fan Motor Speed Selector:
1 = Single Speed Fan Motor.
2 = Two Speed Fan Motor.
3 = Three Speed Fan Motor.
3
5
Continuous Ventilation Setting: what the fan does when
maximum or minimum temperatures are reached.
0= Fan turns off.
1= Fan turns to low speed.
1
6
Set Room Temperature: when in Automatic Fan Speed mode
the fan speed will change in an attempt to maintain the set
room temperature.
22
To Next Page
Need help?
General